Advertisement
job better and more safely at the capacity for which it was intended. Do not modify this equipment, and
do not use this equipment for a purpose for which it was not intended.
5. Check for damaged parts. Before using this product, carefully check that it will operate properly and
perform its intended function. Check for damaged parts and any other conditions that may affect the
operation of this product. Replace damaged or worn parts immediately.
6. Do not overreach. Keep proper footing and balance at all times to prevent tripping, falling, back injury,
etc.
7. DO NOT use the equipment when tired or under the influence of drugs, alcohol, or medication.
A moment of inattention while operating this equipment may result in serious personal injury.
8. Industrial applications must follow OSHA requirements.
SPECIFIC OPERATION WARNINGS
Do not extract caustic or flammable products.
Do not expose the reservoir to any source of heat.
While extracting high temperature oils, keep hands and face protected.
Only use the device for the purpose for which it has been designed.
Do not modify any component of the equipment.
Only use original spare parts.
Never fill the reservoir over the maximum level indicated by the gauge that is located on the side
of the reservoir.
Do not exceed maximum pressure 14.5 PSI for draining.
Open the bottom nut of the reservoir periodically and clean out any dirt to avoid jam.
INSTALLATION
1. Insert the tube (N) into the reservoir, then turn the hand wheel (O) clockwise direction and tighten. Refer to
Fig. 1.
Fig. 1
2. Assemble the handle (B) and the air inlet fitting (K),
turn off the ball valve. Refer to Fig. 2.
3. Assemble the rotor tube, ball valve, O-ring, collecting bowl, filtrating plate
and extension funnel (part# 19-24) orderly. Refer to Fig. 3.
Fig. 2
Page 2 of 5
Fig. 3
Advertisement
