Table of Contents
Advertisement
3.1.5
WWAN Module Installation
Before starting WWAN access on SPG-M041, please remove the upper case of the
SPG-M041.
After opening the cover, refer to the block diagram below to find the position of
WWAN module. Install the WWAN module, and fix antennas to the reserved antenna
holes in the casing.
WWAN module Mini-PCIe:
•
WWAN module installation:
Make sure the IoT gateway is not powered on
•
Make sure the IoT gateway is not powered on
•
Open the case and identify the mPCIe slot on IoT gateway
•
Align the WWAN module/card with the mPCIe slot and push the card straight
•
into the mPCIe slot gently
Secure the WWAN module/card to the pillar on the main board
•
Chapter 3 – Gateway Setup and Configuration
18
Advertisement
Table of Contents
