Advertisement
Quick Links
Advertisement
Related Manuals for Lofrans Dorado
Summary of Contents for Lofrans Dorado
- Page 1 Horizontal Windlasses INSTALLATION AND USER’S MANUAL Dorado - Kobra MADE IN ITALY...
- Page 2 - Drill - 10 mm bit for wood and steel - 10 mm., 13 mm., and 17 mm. hexagon keys exclusively original Lofrans accessories and spare parts, designed manufactured ensure performances, duration and for keeping valid the warranty. • Anchor windl asses used in an •...
- Page 3 In order to operate the anchor windlass correctly, it must be installed to meet the following conditions: 1 – Bow roller height: it must be such to guarantee a chain inclination lower than 90 degrees. 2 – The parallelism between deck floors must be guaranteed;...
- Page 4 The circuit breakers recommended by 2 - Mark and drill as indicated in the Lofrans have an intervention curve and figure. Let the edges of the holes sharp, not a simple plate value. The switches while the edge side of the holes of the...
- Page 6 Make sure the anchor windlass During the use of the anchor is not powered before carrying windlass, do not change directly out manual interventions. from one direction to the other but wait until the anchor windlass stops before manipulating the control into the opposite direction 1 –...
- Page 7 To safeguard the anchor windlass, the hydraulic magnetic circuit breaker is sized so that it comes into action when the anchor windlass is subjected to higher loads than those for which it has been designed. Should it get released owing to an overload reactivate it again and wait some minutes before operating it;...
- Page 8 During mooring, the load on the chain can be very high due to current, wind The warping drum can be used and waves. regardless of the gipsy, to help the mooring manoeuvres. mooring, do not use the anchor windlass as strong point but always 1 –...
-
Page 9: Maintenance
6 MAINTENANCE 6.2 Gipsy maintenance/replacement USE OF THE YACHT (MONTHS) 1 – By turning anticlockwise, remove LESS THAN 2 FROM 2 UP TO 6 MORE THAN 6 CHARTER the gypsy through the manoeuvre EVERY 3 MONTHS handle. 2 – Slip off from the shaft the upper EVERY 6 MONTHS clutch cone, the gipsy, and the lower EVERY 12 MONTHS... - Page 10 Problem Possible causes Solution - Check the protection switch and set it in the ON position Protection switch in OFF position - Check the charge status of the battery, check connections Lack of voltage in the system - Check and possibly replace the control box The anchor windlass does not Failure of the control box work when a control is...
- Page 11 Motor Power Dorado 500W Dorado 700W Kobra 1000W Vessel Lenght Heavy Duty (ft) Vessel Lenght Light Duty (ft) Power Supply Maximum linear Load/Pull (Kg) 2750 Maximum linear Load/Pull (lb) Maximum lift Load/Pull (Kg) 1375 Maximum lift Load/Pull (lb) Max Lift Working Load (Kg)
-
Page 16: Overall Dimensions
10 OVERALL DIMENSIONS... - Page 17 10 OVERALL DIMENSIONS...
- Page 19 Learn more about anchors and docking we have.