Fault
The programme does
not start.
The door cannot
be opened.
The water is not drain-
ing.
Cause and troubleshooting
Laundry is caught in the door.
Open the door again.
1.
Remove any trapped laundry.
2.
Close the door.
3.
Press Inicio/Pausa + Carga
4.
gramme.
The detergent drawer has not been pushed in as far
as it can go.
Push the detergent drawer in as far as it will go.
▶
The pump for the intelligent dosing system is blocked.
Switch off the appliance.
1.
Clean the pump unit.
2.
→ "Cleaning the detergent drawer", Page 45
If this indicator appears again, call our after-sales
3.
service.
→ "Customer Service", Page 64
Note: You can start the washing programme if you de-
activate the intelligent dosing system and dose manu-
ally.
→ "Buttons", Page 23
– – – – is activated.
Continue the programme by selecting
▶
pressing Inicio/Pausa + Carga
→ "Resuming the programme when the programme
status is Rinse Hold", Page 40
The temperature is too high.
Wait until the temperature has dropped.
▶
→ "Cancelling the programme", Page 40
▶
Water level is too high.
Start the
programme.
▶
Power failure.
Open the door using the emergency release.
▶
→ "Emergency release", Page 62
Drain pipe or water outlet hose is blocked.
Clean the drain pipe and the water outlet hose.
▶
Drain pipe or water drain hose is caught or jammed.
Ensure that the drain pipe and water drain hose are
▶
not kinked or trapped.
Drain pump is blocked.
→ "Cleaning the drain pump", Page 47
▶
Troubleshooting en
to start the pro-
or
and
.
55