Table of Contents
Advertisement
en Troubleshooting
Fault
The water is not drain-
ing.
Water is not flowing
in. Detergent is not
being dispensed.
The spin cycle runs
several times.
52
Cause and troubleshooting
Drain pipe or water drain hose is caught or jammed.
Ensure that the drain pipe and water drain hose are
▶
not kinked or trapped.
Drain pump is blocked.
→ "Cleaning the drain pump", Page 44
▶
– – – – is activated.
Continue the programme by selecting
▶
pressing Inicio/Pausa + Carga
→ "Resuming the programme when the programme
status is Rinse Hold", Page 39
The water outlet hose is connected too high.
Install the water outlet hose at a maximum height of
▶
1 metre.
Detergent dosage is too high.
Immediate measure: Mix one tablespoon of fabric
▶
softener with 0.5 litres of water and pour the mix-
ture into the left-hand compartment (not for outdoor
clothing, sportswear or items stuffed with down).
Reduce the amount of detergent for the next wash-
▶
ing cycle with the same load.
Unapproved extension installed on the water drain
hose.
Remove any unapproved extensions from the water
▶
hose. Connecting the appliance
You have not pressed Inicio/Pausa + Carga
Press Inicio/Pausa + Carga
▶
The filters in the water inflow are blocked.
Clean the filters in the water inflow → Page 47.
▶
The tap is turned off.
Turn on the tap.
▶
The water inlet hose is kinked or jammed.
Ensure that the water inlet hose is not kinked or
▶
jammed.
The unbalanced load detection system eliminates an
imbalance by repeatedly redistributing the laundry.
Not a fault – no action required.
▶
Note: When loading, where possible, place large and
small items of laundry together in the drum. Different
sized items of laundry distribute themselves better
during the spin cycle.
or
and
.
.
.
Advertisement
Table of Contents
