Table of Contents
Advertisement
Cleaning and maintenance
en
Machine housing/control
panel
Wipe the housing and the control
■
panel with a soft, damp cloth.
Remove the detergent residue
■
immediately.
Do not clean the appliance with a
■
water jet.
Drum
Use chlorine-free cleaning agents and
not steel wool.
Descaling
Descaling should not be necessary if
the detergent is measured out correctly.
However, if it is required, follow the
manufacturer's instructions for the
descaling agent. Suitable descalers can
be obtained via our website or from our
after-sales service. ~ Page 26
Cleaning the detergent drawer
If the washing machine contains
detergent or fabric softener residues:
Pull out the detergent drawer. Press
1.
down the insert and fully remove the
drawer.
To remove the insert: Push the insert
2.
upwards from below with your finger.
Clean the detergent dispenser tray
3.
and insert with water and a brush,
and dry it. Clean the inside of the
housing as well.
Fit the insert and lock it in place
4.
(push the cylinder onto the guide
pin).
22
Push in the detergent drawer.
5.
Leave the detergent drawer open
Note:
so that any residual water can
evaporate.
Detergent solution pump
blocked
:
Warning
Risk of scalding!
Washing water is hot when washing at
high temperatures. If you come into
contact with the hot detergent solution,
you may be scalded.
Allow the washing water to cool down.
Turn off the water tap so that no
1.
more water can flow in and has to be
drained via the detergent solution
pump.
Turn the programme selector to Off.
2.
Remove the mains plug.
Open the service flap.
3.
Take the drainage hose out of the
4.
holder.
Remove cover flap, drain water into
5.
a suitable receptacle. Press on the
cover flap and insert the drainage
hose into the holder.
Residual water may run out.
Note:
Advertisement
Table of Contents
