Pioneer DV-S633A Operating Instructions Manual page 42

7 DVD Setup Menu
Gain Settings
• Default setting: Fix
You may want to make this setting if you connected
this player to your amplifier using the 5.1 channel
analog outputs.
Under the default setting, all channels are
output at the relative volumes they were
recorded at. Change the setting to Variable if
you want to adjust the relative volume levels of
any of the speakers. Adjustment is in the range
of -6dB to +6dB, in steps of 0.5dB.
• When set to Variable, the overall output level
may sound quieter than when set to Fix. This
is not a malfunction.
Note
Gain settings are not effective when playing a
CD with CD Digital Direct set to On.
A1 Audio2
A1 Audio2
L
C
R
RS
LS
SW
Test Tone
42
En
Language General
Video1 V2
Virtual Surround — Off
Legato PRO — Off
Audio Out — 2 Channel
Speaker Setting
Gain Setting — Fix
Hi–Bit Variable
CD Digital Direct — Off
Select Exit
Move ENTER SETUP
Press ENTER
Language General
Video1 V2
Gain Setting
— 0.0 dB
L R
— 0.0 dB
— 0.0 dB
SW
— 0.0 dB
LS RS
— 0.0 dB
— 0.0 dB
Return
RETURN
Exit
Select
ENTER SETUP
To help you gauge the correct gain levels, set
the Test Tone to On (test tone from just that
speaker) or Auto (test tone from each speaker
in turn, excluding the subwoofer) then adjust
the gain so that all speakers appear to be the
same volume from your listening position.
Follow the on-screen displays to select speakers
and set the channel levels.
• You can adjust the Test Tone setting only
when the player is stopped.
• Many AV amplifiers allow you to make similar
settings at the amplifier stage. In this case,
set the channel levels at the player or the
amplifier, not both.
• As the test tone plays through a speaker, its
name is highlighted in yellow on-screen.
A1 Audio2 Video1 V2
Test Tone
L — Off
C — Off
R
— Off
RS — Off
LS — Off
SW
— Off
Gain ENTER Select
Remember
You can't use the test tone function when the
Audio Out setting is 2 Channel (see page
39).The test tone will not work with the disc
tray open, or while a disc is playing.
CD Digital Direct
• Default setting: Off
Setting this to On increases CD audio quality by
bypassing certain audio circuits in the player
that audio signal would otherwise pass through.
However, this must be set to Off for proper
playback of DTS encoded CDs.
Language General
A1 Audio2 Video1 V2
Virtual Surround — Off
Legato PRO — Off
Audio Out — 2 Channel
Speaker Setting
Gain Setting — Fix
Hi–Bit On
CD Digital Direct — Off
Move
Remember
If this setting is set to On when a DTS CD is
playback, noise is produced.
Language General
L R
SW
LS RS
Return
RETURN
Exit
SETUP
Exit
SETUP