Advertisement
This rack model can be set for a Crossbar spacing distance
2.1
of 6' to 8'. Dimension F illustrates the maximum Crossbar
spacing of 8' from the center hole of the Rear Mounting
Bracket to the center hole of the Front Mounting Bracket.
The Front Mounting Bracket preparation sequence
2.2
is identical to that shown in Steps 1.3–1.5
The Front Mounting Bracket installation sequence
2.3
is identical to that shown in Steps 1.6–1.8
To install the left hand Front Mounting Bracket to
2.4
the vehicle body, repeat Step 2.1 for dimensioning,
then Steps 1.4–1.8 for the Mounting Bracket
installation.
Attach Crossbar Clamps to the Mounting Brackets
2.5
with the Carriage Bolts, Flast Washers and Locknuts
as shown.
NOTE: Recommended Bolt head facing:
Rear Mounts–Bolt heads face rear
Front Mounts–Bolt heads face front
Prime Design Limited Warranty. Seller's sole and exclusive warranty (and Buyer's sole and exclusive remedy and Seller's entire liability for any breach thereof) with respect to the Goods is set forth in the Limited Warranty document available at primedesign.net/warranty-liability
(the "Prime Design Limited Warranty"). ▪ TM & © 2021 PRIME DESIGN. PROTECTED BY ONE OR MORE OF THE FOLLOWING PATENT NO.'s 6427889, 6764268, 6971563, 8991889, 9415726, 9506292, 9481313, 9776476, 9796340, 10470565, 10486608, 10501022 AND OTHER PATENTS PENDING
(F) 6'–8'
2.6
Finger-tighten Clamp Hardware. Do not torque until
Crossbars are mounted.
5
Advertisement
