Advertisement
BRACKET PRE–ASSEMBLY
Attach all six Mounting Braces to the Mounting Brackets using
0.1
the M8 x 25MM Bolts, Flat Washers and Locknuts as shown.
Torque to 90 in-lbs.
MOUNTINGS
Dimension A shows the total distance from the end of the Rear
1.1
Drive Shaft to the center hole of the Rear Mounting.
(A) 29.25"
1.2
To prevent damage
to the vehicle and/or
Ladder Rack, ensure
the Rear Drive Shaft
does not protrude past
the bumper as shown.
Prime Design Limited Warranty. Seller's sole and exclusive warranty (and Buyer's sole and exclusive remedy and Seller's entire liability for any breach thereof) with respect to the Goods is set forth in the Limited Warranty document available at primedesign.net/warranty-liability
(the "Prime Design Limited Warranty"). ▪ TM & © 2021 PRIME DESIGN. PROTECTED BY ONE OR MORE OF THE FOLLOWING PATENT NO.'s 6427889, 6764268, 6971563, 8991889, 9415726, 9506292, 9481313, 9776476, 9796340, 10470565, 10486608, 10501022 AND OTHER PATENTS PENDING
Flush to Bracket
Brace and Bracket
holes are aligned
Mounting Bracket
center hole
Attach all six Mounting Brackets to the Mounting Plates using
0.2
the M8 Allen Flat Head Screws, Flat Washers and Locknuts as
shown, and tighten.
Compare the distances of the screws or rivets on the vehicle
1.3
body to the illustration below. Beginning at the center hole on
the Mounting Bracket, measure against the screws or rivets
to the left and right of the designated center hole as shown
on Step 1.1.
If the vehicle's OEM bolt holes do not align with those on the
Mounting Bracket, it will be necessary to drill the vehicle body
to accommodate either set of Mounting Bracket holes B or C.
Center Hole
(B) 5"
(C) 4"
(D) 8"
(E) 10"
M8 x 35MM
(Top hole)
M8 x 30MM
(B) 5"
(C) 4"
3
Advertisement
