Advertisement
4
The Mounting Bracket must sit flush against the vehicle's body.
1.4
Remove as many bolts or rivets from the area directly behind
the Mounting Bracket as needed for a flush fit.
Attach the Mounting Bracket to the vehicle using the OEM
1.7
body screws retained during Step 1.5, or new rivets.
To prevent water intrusion into the vehicle from
behind the fasteners, it is recommended to use
a seal washer (not included), or apply a small
bead of silicone sealant (not included) behind
the fastener head.
Prime Design Limited Warranty. Seller's sole and exclusive warranty (and Buyer's sole and exclusive remedy and Seller's entire liability for any breach thereof) with respect to the Goods is set forth in the Limited Warranty document available at primedesign.net/warranty-liability
(the "Prime Design Limited Warranty"). ▪ TM & © 2021 PRIME DESIGN. PROTECTED BY ONE OR MORE OF THE FOLLOWING PATENT NO.'s 6427889, 6764268, 6971563, 8991889, 9415726, 9506292, 9481313, 9776476, 9796340, 10470565, 10486608, 10501022 AND OTHER PATENTS PENDING
1.5
If rivets were used for OEM body fasteners,
drill out, discard, and replace with
appropriately sized threaded fastening
hardware.
If bolts were used for OEM body fasteners,
retain and reuse if long enough to provide
sufficient bolt penetration.
Seal washer
(not included)
To prevent water intrusion into the vehicle from behind
1.6
the Mounting Bracket, it is recommended to apply a
small bead of silicone sealant (not included) around
the holes of all removed bolts or rivets.
Silicone sealant bead
To install the left hand Mounting
Bracket to the vehicle body, repeat
Step 1.1 for dimensioning, then
Steps 1.4–1.8 for the Mounting
Bracket installation.
1.8
Torque bolts (if used)
to 90 in-lbs.
1.9
Advertisement
