Mitsubishi Electric PEV-P200YM-A Operation Manual page 19

7. Other Functions
3) Select "OK" with the button.
F4
Filter information
Filter information
Reset filter sign?
Reset filter sign?
Cancel OK
Cancel
OK
F1 F2 F3 F4
F1 F2 F3 F4
A confirmation screen will appear.
Filter information
Filter information
Filter sign reset
Filter sign reset
Main menu:
Main menu:
Navigating through the screens
• To go back to the Main menu ...............
• To return to the previous screen ...........
8. Function Selection
8.1. Function setting
<Function description>
Make the indoor units' function settings from the remote controller as
necessary.
• Refer to the indoor unit Installation Manual for information about the
factory settings of indoor units, function setting numbers, and setting
values.
• When changing the indoor units' function settings, record all the
changes made to keep track of the settings.
Button operation
1) Select Service on the Main menu, and press the
Main Main menu
Maintenance
Initial setting
Service
Main display:
Cursor Page
F1 F2 F3 F4
2) Select Function Setting on the Service Menu screen, and press the
button.
SELECT
Service menu
Maintenance password
Remote controller check
Function setting
Main display:
Cursor
F1 F2 F3 F4
When the
is centrally controlled and the filter sign cannot be reset.
Cool
Mode
If two or more indoor units are connected, filter cleaning timing for each
unit may be different, depending on the filter type.
The icon
cleaning.
When the filter sign is reset, the cumulative operation time of all units
will be reset.
The icon
based on the premise that the indoor units are installed in a space with
ordinary air quality. Depending on the air quality, the filter may require
more frequent cleaning.
The cumulative time at which filter needs cleaning depends on the
model.
button
MENU
button
RETURN
3) The Function Setting screen will appear.
Press the
following: M-NET address, function setting number, or setting value.
Then, press the
desired settings.
Once the settings have been completed, press the
A screen will appear that indicates that the settings information is
being sent.
button.
SELECT
To check the current settings of a given unit, enter the setting for
its M-NET address and function setting number, select Conf for the
Function, and press the
A screen will appear that indicates that the settings are being searched
for. When the search is done, the current settings will appear.
is displayed on the Main display in the Full mode, the system
Fri
Room
Set temp. Auto
Temp. Fan
will appear when the filter on the main unit is due for
is scheduled to appear after a certain duration of operation,
or button to move the cursor to one of the
F1 F2
or button to change the settings to the
F3 F4
Function setting
M-NET address 3
32
Function No.
2
Data
Function Set / Conf
Select:
Cursor Address
F1 F2 F3 F4
Function setting
3
M-NET address
Function No. 32
2
Data
Sending data
button.
SELECT
button.
SELECT
19