Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Rubine RCH-ASPIRA-90SS
Summary of Contents for Rubine RCH-ASPIRA-90SS
- Page 1 REDEFINE THE WAY OF LIFE RCH-ASPIRA-90SS...
-
Page 2: Table Of Contents
READ & SAVE THIS INSTRUCTIONS MANUAL CONTENTS SPECIFICATIONS --------------------------------------------------------------------------------------3 PRODUCT DIMENSION ------------------------------------------------------------------------------3 OPERATNG INSTRUCTIONS -----------------------------------------------------------------------4 INSTALLATION REQUIREMENT -----------------------------------------------------------------6 INSTALLATION PROCEDURES -------------------------------------------------------------------7 MAINTENANCE (installation of charcoal filter) --------------------------------------------------8 IMPORTANT SAFETY INSTRUCTIONS --------------------------------------------------------11 TROUBLE SHOOTNGS -----------------------------------------------------------------------------13 WARRANTY CARD ---------------------------------------------------------------------------------14... - Page 3 Dear Valued Customer, Congratulations and thanks for trusting RUBINE as part of your kitchen appliances. This product is subject to strict Quality Control during the entire process of manufacturing and assembly. It is meticulously tested to ensure lowest defect possible when it is used in your kitchen.
-
Page 4: Specifications
SPECIFICATIONS Model Name : RCH-ASPIRA-90SS Total Power 224W Motor Power : 220W LED Lamp 1x4W 220V – 240V Voltage Frequency 50Hz PRODUCT DIMENSION... -
Page 5: Operatng Instructions
OPERATING INSTRUCTION This is a highly sensitive touch control. Gently press the control to operate. Power / High Hand Sensor Zone Boost Light Delay Speed Speed Power/Delay button: Press the “Power/Delay” button to turn on the range hood, the “Power/ Delay” button flashes, and the range hood will power up. - Page 6 Boost button: In the power-on state, press the “Boost” button once, and the hood will run in the boosted mode. After running for 3 minutes, it will automatically change to the fast speed. This is to provide better suction during deep frying. Light button: Press the light button to turn on the light, and press the light button again to turn off the light.
-
Page 7: Installation Requirement
INSTALLATION REQUIREMENT 1. To have the optimum suction performance, do not install cooker hood near to door and windows. External wind will reduce the efficiency of the range hood. (Fig. 1) 2. Install range hood directly above the hob. The optimum distance between the cooker good and hob is 300mm to 350mm. -
Page 8: Installation Procedures
INSTALLATION PROCEDURES SAFETY WARNING Some parts of the range hood may have very sharp edges. Please wear protective gloves if you need to remove any parts during installation, cleaning or servicing. Make sure the wall able to hold / withstand the weight of cooker hood. It should not have contact with any cable inside / outside to avoid electric shock. -
Page 9: Maintenance (Installation Of Charcoal Filter)
MAINTENANCE To ensure efficiency & product lifespan, clean the range hood surface & motor regularly. Before any cleaning & maintenance, make sure the range hood is switched-off and unplugged. Wear glove during maintenance to avoid injuries or scratching the range hood. Use mild soap or detergent solution to clean the surface once a week depending on the usage Motor fans and other internal part should be cleaned once every 6 months, depending on usage. - Page 10 For Charcoal Filter Installation 1. Remove out the oil filter (A). Then remove the three screws from the lower panel (B). Then Push up and take out the glass panel (C). 2. Remove the four screws on the upper panel and remove the baffle filter (A). Then, install the charcoal filter to the location show by Arrow (B).
- Page 11 Cleaning of the component Use mild soap or detergent solution to clean the component. Do not use organic solvents. Soak it for 30 minutes before wash. Ensure to avoid any damages to the component. After clean it with mild soap or detergent solution, wash it again with water & wipe it with dry cloth.
-
Page 12: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS:... -
Page 14: Trouble Shootngs
TROBLESHOOTINGS Malfunctions Causes Action LED light is not install LED light Contact service centre & malfunction LED light is not install request technician to: while motor is correctly - install the LED light operating - replace new LED light LED light broken Plug &... - Page 16 Contact : 03 – 6286 9000 Website : http://www.e-quality.com.my/ 1-year 1. Log on to www.rubine.com.my 2. Click on ‘Support’, followed by ‘Products Warranty Registration’ to proceed. You are required to sign up as a member. 3. Please fill up the necessary information, tick on the Checkbox and click ‘Next’.
Need help?
Do you have a question about the RCH-ASPIRA-90SS and is the answer not in the manual?
Questions and answers