Product introduction Thank you for purchasing this Luxibel product. For your own safety, please read the instruction manual carefully before turn on the product for the first time. Before unpacking the fixture, please make sure that the packaging is in good condition and that following items will be found in the box: •...
Safety Notes Each person which is responsible for the installation, the usage of service of this unit must be qualified and has to follow the instruction in this manual. Be careful when using the device. You risk an electrical shock from high voltage, if you touch the wires! The device has left our company in manufactured proofed state.
Page 5
measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/ TV technician for help.
Page 6
Please make sure minimal 0.5m distance need to kept between the fixture to any --0.5m flammable material. The device can only run with 100-240V voltage, 50/60 Hz power, don’t connect to any other wrong power. Disconnect the device from main power before open the shield or maintenance.
Maintenance Operation only allowed to qualified person, damages due to unprofessional operation or remove of any parts inside will not be considered in warranty service. There are no serviceable parts inside the device or package, service only leaves to authorized dealers. Never allow the optical components contact with oil, fat or any other liquid.
Installation There are specific regulations like BGV C1 (old VBG 70) or country related regulations which need to attend during the installation. The installation has to be handled by skilled persons only! Suspension device hast to be built and calculated in order to handle up to 10 times its specific load limit over a time of one hour without permanent or harmful deformation.
Page 9
Installation of the B EXPO350M The device could be either put on a solid and even surface, or mounted upside down or sideways like left picture. The mounting place must be sufficient stable and be able to support a weight of 10 times of the unit’s weight.
Control Menu Menu tree Default settings shadowed. MODEL NAME:B EXPO350A DMX Addr① dmx mode 8ch /9ch Max Temp① (85℃)(185F) 80~130℃/176~266℉ Dimmer① 0-255 dimmer fine zoom tilt strobe Lamp Temp XXXC FAN1: XXXR FAN Speed FAN2: XXXR FAN3: XXXR soft version V1.0 Temper.
DMX Mode DMX addressing The device is controlled by universal DMX 512 protocol, DMX address is the start channel used to receive instructions from the external controller. For independent control, each fixture must be assigned its unique address control channels. For example, this device has four channel modes: 20/21/15/17, if we set the mode at standard 18 channels mode, and there are several models need to be independently controlled, we just simply address first fixture at 1, and second fixture at 21, third one at 41, etc.
Page 13
Unique features RDM, stand for “Remote Device Management”, with this function, users can realize remote control of the device, such as remotely changing DMX address, check a lot of useful information such as temperature, power consumption, fan speed. Etc. Every single device has a unique RDM code before left factory to distinguish from each other, usually not suggest users change this code freely.
Technical Specifications Dimensions drawing Physical Dimensions (WxHxD): 46,7 x 40,4 x 32,0 cm | 18,4” x 15,9” x 12,6” Packaging dimensions (WxHxD): 51,1 x 43,9 x 38,6 cm | 20,1” x 17,32” x 15,16” Net weight: 10,5 kg | 23,2 lbs Gross weight: 11,5 kg | 25,4 lbs Mounting options Hanging: 3x M12 hole...