Table of Contents
Advertisement
Pre-Failure Frames
Post-Failure Frames
Max allowable video threshold
failures
Max allowable consecutive video
failures
Max allowable audio threshold
failures
Max allowable consecutive audio
failures
Allowable Audio Offset Range
Allowable Audio Loudness
Range
Auto Delete
Save Screen Shot
Delay Frames
Clear Logs and Recordings
01/29/2019
frames and may write a bigger file up to this limit.
Number of frames setting. Set the number according to frames
required to be recorded before any video or audio threshold failure
and error condition recording.
Number of frames setting. Set the number according to frames
required to be recorded after any video or audio threshold failure
condition or score becomes within threshold set.
This value defines how many video quality failures are needed to
trigger a recording within the Minimum Capture Frames.
This value defines how many consecutive video quality failures are
needed to trigger a recording within the Minimum Capture Frames.
NOTE: if dynamic re-alignment is checked and an alignment problem
is detected, then errors will be reset.
NOTE 2: consecutive failures should be set lower than allowable
failures.
This value defines how many video quality failures are needed to
trigger a recording within the Minimum Capture Frames.
This value defines how many consecutive video quality failures are
needed to trigger a recording within the Minimum Capture Frames.
NOTE: consecutive failures should be set lower than allowable
failures.
This should probably be set to the SMPTE specification based on
which points are measured. It is a variable because SMPTE defines
the range based on the measuring points.
This is the range that is acceptable. RTM will alarm if the loudness
falls outside of this range.
If the disk fills to near maximum, sequences will need to be deleted.
This flag enables deleting the oldest files or the newest files.
When an error occurs, the video frame that triggered the error (even if
it is a VANC or Audio quality error) can be saved as a single image.
This saves to save the screen shot X frames after the triggered event.
RTM will delete all of the current logs, and recordings when starting
the application.
Rev.3.0
28 of 40
Advertisement
Table of Contents
