Table of Contents
Advertisement
Spatial Offset
Average Period
Graph Minimum Value
Graph Maximum Value
Field Mode
Enable Metric Window Overlay
Stop After Once Through
Comparing Sequence to Live
Input
01/29/2019
NOTE: X, Y, W, and H will be automatically set.
This is carried over from the RTM main alignment pane. You can set
it here as well.
Defines how often the file psnrAvg.Log or dmosAvg.Log will be
updated. This logfile contains the Min, Max, Average, and Mean
values for this many seconds or frames of video.
Normally, the graph is shown on a 0 to 100 scale where 100 is perfect
quality. You can change this if you know that your normal values are
between 0 (minimum) and 40 (maximum) to make the graphs easier
to read.
NOTE: the real values will be measured and logged.
Normally, the graph is shown on a 0 to 100 scale where 100 is perfect
quality. You can change this if you know that your normal values are
between 0 (minimum) and 40 (maximum) to make the graphs easier
to read.
NOTE: the real values will be measured and logged.
This flag forces RTM to run in field mode instead of frame mode. It
will compensate for field roll.
NOTE: it will not compensate for field flip
This setting, when checked, will place a green colored box upon the
incoming video thumbnails on the RTM main screen for a visual
representation of the Video Metric Window or area of measurement
setting.
This selection stops the RTM session when comparing input to a file
after the file has completed playing once. Unchecked will continue to
loop the file and compare to incoming video feed (assuming that
incoming video is also the same video in a loop).
Rev.3.0
24 of 40
Advertisement
Table of Contents
