Light Button - Haier AS09PCEHRA Operation Manual

Operation
• Comfortable SLEEP
Press button , the remote controller will
SLEEP
show , and then achieve to the sleep function.
Press again this button , the sleep function will
SLEEP
be cancelled.
Operation Mode
1. In COOL,DRY mode
1 hour after SLEEP mode starts.temp will become
1 ° C higher than temp setting. After another 1 hour,
temp risesby 1 C futher .The unit will run for further
°
6 hours then stops Temp is higher than temp setting
so that room temperature won't be too low for your
sleep.
operation sta
SLEEP
Temp.setting
In COOL, DRY mode
2.ln HEAT mode
1 hour after SLEEP mode starts, temp will become
沪C lower than temp setting. After another 1 hour,
temp decrease by 2°C further. After more another 3
hours, temp rises by 1 c further.The unit will run for
°
further 3 hours then stops.Temp is lower than temp
setting so that room temperature won't be too high
for your sleep.
Temp.setting
1 1 h
3 hrs
SLEEP
operation starts
In HEAT mode
3.ln AUTO mode
The unit operates in corresponding sleep mode
corresponding sleep mode adapted to the
automatically selected operation mode.
4. In FAN mode
It has no SLEEP function.
ts operation stops
SLEEP
「
Approx.6hrs
1 � 二
Unit stop
Unit stop
:Oecreases 2'C
二
3 hrs
SLE. E P
operation stops
5. When comfortable sleeping function is set to 8 hours the
comfortable sleeping time can not be adjusted.When TIMER
function is set,the comfortable sleeping function can't be set
up. After the sleeping function is set up,if user resets
TIMER function, the sleeping function will be cancelled; the
machine will be in the state of timing-on,if the two modes
are set up at the same time,either of their operation time is
ended first, the unit will stop automatically,and the other
mode will be cancelled.
Note
When TIMER function is set, the sleeping function can't be
set up .After the sleeping function is set up,if user resets
TIMER function, the sleeping function will be cancelled; the
machine will be in the state of timing-on.
Power Failure Resume Function
If the unit is started for the ti
「
start running unless 3 minutes have elapsed. When the power
resumes after power failure, the unit will run automatically,
and 3 minutes later the compressor starts running.
Healthy Airflow Operation
1.Press to starting
Setting the comfort work conditions.
2.The setting of healthy airflow function
1)Press the button of health airflow ,
display.Avoid the strong airflow blows direct to the body.
2)Press the button of health airflow again,
display. Avoid the strong airflow blows direct to the body.
3. The cancel of the healthy airflow function
Prss the button of health airflow again, both the inlet
and outlet grills of the air conditioner are opened,and
the unit goes on working under the condition before the
setting of airflow function.After stopping, the outlet grille
will close automatically.
Note:
1.After setting the healthy airflow function, the position
grill is fixed.
2.In cooling, it is better to select the
3.In cooling and dry, using the air conditioner for a long
time under the high air humidity, condensate water may
occur at the grille .

LIGHT Button

Control the lightening and extinguishing of the indoor
LED display board.
st time, the compressor will not
HEALTH
AIRFLOW
appears on the
appears on the
mode.