Fitting/Changing The Roughing/Cutting Disc - Parkside PWSAP 20-Li D4 Original Instructions Manual

Fitting/changing the roughing/
cutting disc
Always wear protective gloves when changing
cutting/roughing discs.
Pay attention to the dimensions of the roughing/
cutting disc. The diameter of the hole must fit to the
mounting flange i without any play. Do not use a
reducer or adapter.
NOTE
► Use only discs which are free of dirt.
► Disc size of grinding disc:
Ø 125 x 22.2 x 6 mm
► Disc size of cutting disc:
Ø 125 x 22.2 x 3mm
■ Use only grinding discs whose permissible
speed rating is at least as high as that on the
type plate on the power tool.
■ RISK OF INJURY! Press the spindle locking
button 9 only when the mounting spindle u
is at a complete standstill.
♦ Press the spindle locking button 9 to lock the
gearbox.
♦ Undo the clamping nut o by hand or using the
two-hole assembly spanner p (see fig. D).
Fold the bracket of the clamping nut oupwards
and loosen it counterclockwise.
♦ Place the roughing or cutting disc with the label
side towards the tool on the mounting
flange i.
♦ Then replace the clamping nut o on the
mounting spindle u with the raised side
facing up.
■ 12 │ GB │ IE
With thin grinding discs (see fig. 1)
♦ The collar of the clamping nut o always faces
upwards so that a thin grinding disc can be
fitted safely.
Fig. 1
♦ Press the spindle locking button 9 to lock the
gearbox.
♦ Retighten the clamping nut o clockwise by
hand or using the two-hole assembly span-
ner p.
NOTE
► If the disc does not turn smoothly or vibrates
after the change, the disc must be replaced
immediately.
♦ For safety's sake, run the tool at maximum
speed for 60 seconds after every disc change.
Be aware of unusual noises and sparks.
♦ Check whether all fastening elements are
correctly fitted.
♦ Make sure that the arrow showing the direc-
tion of rotation (if any) on the cutting or rough
grinding discs (including diamond cutting
discs) and the direction of rotation of the tool
(arrow showing the direction of rotation on the
head) match.
PWSAP 20-Li D4