Siemens HR976GM.1 User's Manual & Installation Instructions page 34

Table of Contents

Advertisement

en Rails
4.
Note: The lettering "Pyro" must be legible at the top,
as shown in the picture.
Slide the inner pane into the retainer at the bottom
​ ⁠ and fit it at the top.
5.
Push the inner pane in at the top
caps
​ ⁠ downwards in the direction of the arrow.
24  Rails
To thoroughly clean the rails and the cooking compart-
ment, or to replace the rails, you can remove the rails.
24.1 Detaching the rails
WARNING ‒ Risk of burns!
The shelf supports get very hot
Never touch the shelf supports when hot.
Always allow the appliance to cool down.
Keep children at a safe distance.
1.
Lift the rail forwards slightly
2.
Pull the whole rail to the front
3.
Clean the rail.
34
​ ⁠ . Push the sliding
​ ⁠ and detach it
​ ⁠ .
​ ⁠ and remove it.
6.
Open the appliance door fully.
7.
Close the locking levers on the left- and right-hand
hinges
8.
Close the appliance door.
Note: Do not use the cooking compartment again until
the door panes have been correctly fitted.
24.2 Attaching the rails
Notes
¡ The rails only fit on the right or left.
¡ For both rails, ensure that the curved rods are at the
front.
1.
First, push the rail into the middle of the rear
socket  ​ ⁠ until the rail rests against the cooking
compartment wall, and then push this back
2.
Push the rail into the front socket
also rests against the cooking compartment wall,
and then press this downwards
​ ⁠ .
​ ⁠ until the rail
​ ⁠ .

Advertisement

Table of Contents
loading

Table of Contents