Page 1
Instruction manual MARK Secure 3 Anchor point for solid wood ceiling, suspended ceiling system, socket installation Anchor device type A according to EN 795:2012 MARK Save A Life GmbH Gleinkerau 23 4582 Spital am Pyhrn Austria/Europe Tel. +43 (0) 7563 8002 111...
1.2 Labelling the information difficult to understand. Ensure that the fall The MARK Secure 3 anchor point is intended for use as Your product is labelled with a batch number. space is calculated so that in the event of a fall you do not...
2 x deformation brackets Installation: 2 x hexagon head wood screws 12 x 100 This product may only be installed as per this instruction manual. MARK Save A Life GmbH recommends it is installed by galvanised a specialist company. 2 x washers for diameter M12 4 x screws M8 x 25 8.8 galvanised...
Page 6
Secure socket C and anchor point A with report (enclosed). Observe periodic inspections. 2 countersunk screws D. When doing so, the Observe instructions for use for MARK Secure 3 “front side” marking on the buckle must be visible. on the following pages.
If it is stored and installed correctly and not subjected to a the reservation that components of the product have not MARK Save A Life GmbH is committed to protecting and knowledge, nor does it release you from your own load, this product has an unlimited service life.
Page 8
Notes 10.1.2 What can you do to stave off suspension 10.1.3 What first aid measures can you instigate? trauma if you need to be rescued? Call the emergency services. Kick one foot firmly against the other and point Lower the person who needs to be rescued. ...
Page 9
Installation report for MARK Secure 3 Installation report for MARK Secure 3 Solid wood ceiling, suspended ceiling system, socket installation Solid wood ceiling, suspended ceiling system, socket installation The completed installation report for the anchor points listed below confirms that installation has been carried out The completed installation report for the anchor points listed below confirms that installation has been carried out properly in line with the instruction manual for the product.
Page 10
Installation MARK Secure 3 construction kit supplied in full Instruction manual read and understood Solid wood installation base ≥ C 24 Distance of the drilled holes from the edge ≤ 50 mm Screw-in depth of the wood screws ≥ 100 mm Drilled holes = 6 mm All parts of the construction kit used in full.
Page 11
Fax: +43 (0) 7563 8041 111 mark@savealife.at All rights reserved. It is only www.savealife.at permitted to make changes to, reprint photographically reproduce this document, in whole or in part, with the express consent of MARK Save A Life GmbH, Gleinkerau 23, 4582 Spital am Pyhrn.
Need help?
Do you have a question about the Secure 3 and is the answer not in the manual?
Questions and answers