ABB HT564330 Operation Manual page 89

WARNING
© Copyright 2016 ABB. All rights reserved.
Removal and installation
Remove the turbocharger
Remove the insulation shell from the bearing casing and turbine-end

foot. Leave the remaining insulation on the turbocharger.
Version with compressor wheel cooling system
Dismantle the air supply line (also see the chapter entitled Preliminary

remarks / Layout and functioning).
Inspect the lifting gear.

Fasten the lifting gear to the suspension lugs on the bearing casing

and on the turbine-end foot.
Unplug the cable connector on the speed sensor.

Unscrew the fixing screws on the feet.

Lift the turbocharger off the engine and set it down to one side.

If support for the turbocharger is not provided or is inadequate, the
turbocharger could tip over during installation or removal and cause a
serious or even fatal injury.
Support the turbocharger at a suitable point.

Cover the oil connection.

Operation Manual / TPL76-C
7
7.2 Page 87