Table of Contents
Advertisement
•
Continue with this process until no more preserving
agent escapes.
•
Close the suction, pressure and operating liquid
connection (UB) using transport or sealing covers.
•
Plug all drainage bores (Ue) with screw plugs.
4.4 Removing preserving agent
Only required for aggregates treated with preserving
agent.
C AU T I O N
Risk of bearing damage caused by excessive water
pressure or splash water!
▶ Do not treat bearing areas with water or steam jet.
C AU T I O N
Risk of seal damage caused by improper cleaning agents!
▶ Ensure that cleaning agents do not harm the seals.
1. Use cleaning agents which are appropriate for your
respective application.
2. Rinse off preserving agent and collect it together with
the rinsing agent.
3. Dispose of preserving agent according to local
regulations.
4. For storage periods exceeding 6 months:
− Replace elastomer components made of EP rubber
(EPDM).
− Check all elastomer components (O-rings, shaft
sealings) for proper elasticity and replace if required.
4.5 Disposal
Risk of intoxication and environmental damage caused
by media to be pumped!
▶ Prior to disposing the aggregate:
− Collect escaping media to be pumped and dispose of
separately in accordance with local regulations.
− Neutralize residues of media to be pumped in the
aggregate.
− Disassemble plastic parts and dispose of in
accordance with local regulations.
▶ Assign an authorized company to dispose of the
aggregate to prevent the risk of environmental damage!
13
255548 Rev.1
WA R N I N G
Advertisement
Table of Contents
