Product Registration; Unpacking: Important Points Before Setup - Wilson Benesch FIBONACCI Series User Manual

1.0 Product Registration

Please register your product within 30-days of receipt of your Wilson Benesch product. Completion of the product registration within 30-days of receipt will validate a
full 5-year warranty provided all conditions detailed in section '4.7 - Limited Warranty' are satisfied. Please refer to our terms and conditions at the back of this product
manual for more information. Product registration can be completed by returning the 'Product Registration' card that is supplied with your Fibonacci Series product,
please complete all fields fully to validate your product warranty.
1.1 Unpacking: Important points before setup and Warnings
Before unpacking your new Wilson Benesch loudspeakers, please observe the instructions in this manual. Furthermore, please note the check list on the opposite page for
what is included in the product packaging.
During installation please observe normal procedures for lifting and correct posture when handling the speakers. It is strongly recommend for the smaller products that
two people work together to unpack the product. With the largest products in the Fibonacci Series at least three people will need to work together to unpack the product
and safely install it. Never attempt to unpack or install speakers without assistance as this can result in damage or personal injury. It is strongly recommended that all
watches and jewellery be removed prior to unpacking and gloves worn to allow better grip of the product and protection to the surface finish.
Patient and careful setup is essential to obtain the maximum performance from this system. Special care and attention must be taken to ensure that no pressure is
applied to the drivers and in particular, the tweeter dome, when handling or moving the product from the packaging.
Once the speakers have been stood in an upright position on their terminations the supplied protective coverings can be removed and the packaging stored for future use.
This packaging is essential for safe shipment of the product. It is designed and tested specifically for use with this product. Due to the bespoke nature of the packaging,
replacement costs are not insignificant and it is highly recommended therefore, that the packaging is retained for any potential later use.
FIBONACCI SERIES MANUAL REV 1.0
4