Product Registration - P4; Unpacking: Important Points Before Setup - P4; Removing The Tweeter Protector - P4 - Wilson Benesch PRECISION Series User Manual

1.0 Product Registration
Please register your product using the Warranty Registration Card provided in the product packaging within 30-days of reciept of your Wilson Benesch product. Return
within 30-days of reciept will validate a full 5-year warranty provided all conditions detailed in section '5.0 - Limited Warranty' are satisfied. Please refer to our terms and
conditions at the back of this product manual for more information.
1.1 Unpacking: Important points before setup
On the outside of the shipping carton you will find a QR code which will automatically load an unpacking video on your device. It is possible to unpack the Precision Series
products alone, but we recommend at least 2-people work together to avoid damage to the product or personal injury. Please observe normal procedures for lifting and
correct posture when handling the speakers. It is strongly recommended that all watches and jewellery be removed prior to unpacking and gloves worn to allow better
grip of the product and protection to the surface finish. Patient and careful setup is essential to obtain the maximum performance from this system.
Special care and attention must be taken to ensure that no pressure is applied to the drivers and in particular, the tweeter dome, when handling or moving the product
from the packaging.
Once both speakers have been stood in an upright position on their spikes the bags can be removed and the packaging stored for future use. This packaging is essential
for safe shipment of the loudspeaker. It is designed and tested specifically for use with the Precision Series. Due to the bespoke nature of the packaging, replacement
costs are not insignificant and it is highly recommended therefore, that the packaging is retained for any potential later use.
1.2 Removing the Tweeter Protector
All Precision Series products come with a tweeter protector installed. The P1.0 tweeter protector is slightly different from the P2.0/P3.0. But the removal of the protector is
the same in each instance. Place two fingers from one hand on the faceplate and hold it in place, whilst using the other hand to pull the mounts away from the faceplate
freeing the protector. This is shown in the unpacking film.
PRECISION SERIES MANUAL REV 1.3
4