Bi-Amping; Bi-Wiring; Terminals - Wilson Benesch FIBONACCI Series User Manual

3.0 Bi-Amping

Bi-Amping can give the amplifiers more control over the drivers, separating these systems can deliver benefits but it is not always the best solution and must be
experimented with. It is generally not recommended to bi-amp using different types and/or makes of amplifier for different driver sections.

3.1 Bi-Wiring

Improvements can be heard through separating the energy from each filter in the crossover. Cables vary in construction but a good quality cable should be low in
impedance, inductance and capacitance. Do not use cables that act as additional crossover components. Experimentation is crucial in this situation and a cable that works
well in one situation with a given amplifier may not always perform as well when one of these variables is changed.

3.2 Terminals

Wilson Benesch recommends the use of 8mm ring or spade connector cable terminations. A spanner is provided to tighten up the rhodium plated nuts. A light pinch of the
end of the supplied spanner is more than sufficient to tighten the nuts. Please be careful to not over tighten the terminals as this could result in damage to the terminal
plate or snapping of the terminal. The terminals will also accept 4mm banana plugs.
FIBONACCI SERIES MANUAL REV 1.0
10