Page 1
INSTALLATION, OPERATION & MAINTENANCE GUIDE STYLE 85/85M SPLIT CARTRIDGE SEAL Headquarters Brazil Gulf Coast Texas 291 Hurricane Lane Rua Javaés, 441/443 1719 South Sonny Avenue Houston Williston, VT 05495 Bom Retiro, Sao Paulo Gonzales, LA 70737 7545 E. Orem Drive...
Page 2
NOTICE Flexaseal does not assume responsibility for misuse, or any damages incurred as a result of the misuse of the supplied sealing system. Contact a Flexaseal representative before making any changes to the provided system or design.
Page 3
Installation, Operation, & Maintenance Guide Style 85/85M Split Cartridge Seal PREPARATION 3. Clean the shaft, shaft sleeve (if present), and seal chamber face of rust, burrs, grit, sharp • Verify that equipment has been properly edges, and set screw damage using fine emery shut off and rendered inoperative according cloth.
Page 4
Installation, Operation, & Maintenance Guide Style 85/85M Split Cartridge Seal VERIFICATION Successful operation of a Style 85/85M Split Cartridge Seal is contingent on conforming equipment dimensions and alignment. Verify the following prior to continuing: Figure 2: Shaft Runout Figure 3: Bearing Fit...
Installation, Operation, & Maintenance Guide Style 85/85M Split Cartridge Seal SEAL INSTALLATION The advantage of a Style 85/85M Split Cartridge any lubricant on the end of the O-rings where Seal over a typical cartridge seal is seen in the ease they are split.
Page 6
Installation, Operation, & Maintenance Guide Style 85/85M Split Cartridge Seal Figure 8: Exploded view of split cartridge Figure 9: Installation of split cartridge Page 5 of 10...
Installation, Operation, & Maintenance Guide Style 85/85M Split Cartridge Seal BEFORE STARTING THE EQUIPMENT 1. Ensure the pump shaft is properly aligned at 6. Ensure all plumbing and venting are free of the coupling with the motor. obstruction and that the chamber is filled with liquid.
Installation, Operation, & Maintenance Guide Style 85/85M Split Cartridge Seal REMOVING THE SEAL • Before opening the pump to remove the seal the warning stated above regarding toxins and hazardous products must be reiterated. Make note of all fluids contained in the pump, drain and decontaminate before opening the housing for seal service.
Page 9
Installation, Operation, & Maintenance Guide Style 85/85M Split Cartridge Seal STYLE 85 DIMENSIONAL DATA (INCH) Page 8 of 10...
Page 10
Installation, Operation, & Maintenance Guide Style 85/85M Split Cartridge Seal STYLE 85 DIMENSIONAL DATA (METRIC) Page 9 of 10...
Page 11
SEAL PRODUCTS Flexaseal Engineered Seals and Systems, LLC (hereinafter referred to as "FAS") warrants that new goods manufactured by FAS (with the exception of "wear parts" or consumables all of which are not warranted) will be free from defects in material and workmanship (the “Warranty”).