Digital Thermostat (On Certain Models); Digital Thermostat (Scr610Bl & Scr1156) - Summit Appliance accucold PLUS Series Use & Care Manual

Digital thermostat (on certain models):

If you find it necessary to change the temperature setting for your digital-thermostat
controlled appliance, please refer to the following instructions. The front panel of the
thermostat is illustrated here:
During normal operation, the display shows the
internal cabinet temperature.
To see the SET POINT:
Push and immediately release the set key. The LED will flash and show the set point
value. Wait 15 seconds and the inside temperature will display again. Typically,
refrigerator models are set at 4°C and freezers at -18°C.
To change the SET POINT:
Push set and within 15 seconds, press ▲ or ▼ until the desired set point is shown.
The new setting will be memorized after 15 seconds provided no other keys are
pushed, or you can press the set key immediately.
Notes: 1. The minimum and maximum limits of the temperature range of your
thermostat are preset and locked by us. For refrigerator models, that range is
36°F to 46°F. For most freezers, the range is -25°C to -1°C. (For freezer
ACF48WMEDDT, the range is -20C to -12C).
2. If the appliance is unplugged, has lost power or is turned off, you must wait 3 to
5 minutes before restarting the unit. If you attempt to restart before this time
delay, the appliance will not start.
Digital thermostat (SCR610BL & SCR1156 models):
ON/OFF Power:
To turn the appliance ON or OFF, touch the
and hold for 5 seconds.
NOTE: Pressing the POWER key once can switch off the
audible alarm when the alarm is on.
:
UP
Used to increase (warm) the set temperature by 1°C/1ºF.
DOWN :
Used to decrease (cool) the set temperature by 1°C/1ºF.
Interior Light
Touching the LIGHT symbol toggles between 2 modes of operation for the internal
lights: functional (default) mode and showcase mode. If you are in functional (default)
mode, the lights will turn on only when the door is open. If you are in showcase mode,
the lights will be on whether or not the door is open.
ºF/ºC Selector:
Select the temperature display in Fahrenheit or Celsius degrees. To change the
temperature from Fahrenheit to Celsius or from Celsius to Fahrenheit, press and hold
the LIGHT key for 5 seconds.
:
set
symbol
10
°C
°F
▼ ▲
Control panel