Changing The Projection Mode Using The Menus; Adjusting The Image Height - Epson CO-W01 User Manual

• Front/Upside Down flips the image over top-to-bottom to project upside-down from a ceiling or wall
mount.
• Rear flips the image horizontally to project from behind a translucent screen.
• Rear/Upside Down flips the image over top-to-bottom and horizontally to project from the ceiling and
behind a translucent screen.
Note: You can change the projection mode using the remote control or by changing the Projection
setting in the Settings > Installation menu.

Changing the Projection Mode Using the Menus

Parent topic:
Related references
Projector Feature Settings - Settings Menu
Changing the Projection Mode Using the Menus
You can change the projection mode to flip the image over top-to-bottom and/or left-to-right using the
projector menus.
Note: You can also press and hold the
seconds to flip the image upside-down.
1. Turn on the projector and display an image.
2. Press the
3. Press the arrow buttons to select the Settings > Installation > Projection setting and press Enter.
4. Select the projection mode you want to use and press Enter.
5. Press the
Parent topic:
Related references
Projector Feature Settings - Settings Menu

Adjusting the Image Height

If you are projecting from a table or other flat surface and the image is too high or low, you can adjust the
image height using the projector's adjustable foot.
Using Basic Projector Features
A/V mute button on the projector remote control for about 6
menu button on the projector remote control.
menu button to exit the menu or the
Projection Modes
return button to return to the previous screen.
56