NETGEAR WAX628 User Manual page 183

Insight Managed WiFi 6 AX5400 Access Point Model WAX628
- Ethernet LLDP: The status of Ethernet LLDP feature (Enabled or Disabled).
- Country / Region: The country or region in which the access point operates
or for which the access point is licensed.
-
Current Firmware Version: The version of the firmware that is running on
the access point.
-
Backup Firmware Version: The version of the backup firmware on the access
point.
- Bootloader Version: The primary bootloader (U-Boot) version that is installed
on the access point.
- Serial Number: The serial number of the access point.
- Current Time: The current system time of the access point.
- Uptime: The time since the access point was last restarted.
• AP Interface Status: A green icon indicates that the interface is in use. A gray
icon indicates that the interface is not in use.
• IPv4 Settings section: The following settings are displayed:
- IPv4 Address: The IPv4 address of the access point.
-
Subnet Mask: The subnet mask of the access point.
- Default Gateway: The default gateway for the access point.
- DHCP Client: The status of DHCP client (Enabled or Disabled).
• Wireless Settings section: The following settings are displayed, with separate
columns for the 2.4 GHz and 5 GHz radios:
- Antenna: The type of antenna (by default, 4x4).
-
Wireless Mode: The operating WiFi mode of the radio.
- Channel / Frequency: The channel and frequency that are used by the radio.
Monitor the Access Point and the
Network
183 User Manual