Table of Contents
Advertisement
1 - SAFETY INSTRUCTIONS
Installation, start-up and maintenance operations for this equipment may be dangerous if certain factors particular to this installation,
such as the presence of electrical and live components and the installation location, are not taken into account.
Before any operation, read this guide carefully and keep it in a safe place. Safety information must be adhered to.
Only experienced, authorised, qualified installers and technicians, who have undergone specific training on the product in question,
are permitted to install, commission and service this equipment.
This device is not designed to be used by persons (including children) with limited physical, sensory or mental capabilities, or by
persons with insufficient experience or knowledge.
Follow the operating precautions to the letter when working on the unit. Labels have been placed on the unit to remind you of the
safety instructions.
As a general rule, follow all applicable safety regulations and standards.
Damage to the dual flow air handling unit will be disregarded in the event of failure to follow the instructions in this document.
During any servicing operations, all the recommendations and instructions given in the maintenance brochures, on the labels or in the
instructions accompanying the equipment must be observed, along with any other applicable safety instructions.
■ Observe all the regulations in the safety codes.
■ To prevent any risk of accident, prohibit public access by clearly marking the work area.
■ Wear all the required Personal Protective Equipment (PPE).
■ Follow the handling instructions.
■ Handle heavy and bulky equipment with care when lifting, handling and setting down.
■ Technicians who install, commission, operate and service the unit must understand the instructions given in this manual and be
familiar with the specific technical characteristics of the installation site.
■ Unauthorised persons and the general public must be prevented from accessing this device.
For your safety, we recommend the use of PPE (Personal Protective Equipment)
PROTECTION AGAINST ELECTROCUTION
Only personnel qualified in accordance with the IEC (International Electrotechnical Commission) recommendations must be allowed
to access the electrical components. It is particularly recommended that all the electrical supplies to the unit are switched off before
any work is carried out. Cut the main power supply using the disconnect switch or circuit breaker.
IMPORTANT: The control system includes electronic components. These may cause or be subject to electromagnetic
disturbance if they are not installed and used in accordance with these instructions.
Before carrying out any work on the frequency inverters (heat recovery wheel, etc.), disconnect the power supply and ensure
that these are not live. After disconnection, you must wait 5 minutes before starting work (necessary for the capacitors to
discharge).
3
Advertisement
Table of Contents
