Download Print this page
Rapidline PO500 Assembly Instructions

Rapidline PO500 Assembly Instructions

Chair

Advertisement

Quick Links

Assembly Instructions:
Product Code : PO500
Product Name: PO500 Chair
Time Required:
10 minutes
Tools Required:
Screwdriver, Electric Drill, Pencil, Measuring tape/Ruler
*Tools are not included.
Skill Required:
Easy
The Assembly Skill Rating is a 5-point system that shows the degree of e ort needed in assembling
a speci c product. With 1 being easy for the average person and 5 requiring an expert.
For most products, two persons are recommended.
• As this is a commercial product, some intermediate skills may be required.
• If you are missing any hardware, please contact your Rapidline reseller. Please ensure you have the name of the item,
• Assemble on a clean, at, smooth surface such as a rug or carpet to avoid parts from being scratched.
• Remove all wrapping materials, including staples and packing straps before you start to assemble
• Do not use this product unless all bolts and screws are rmly secured and tightened.
• If parts are missing, broken, damaged or worn stop using the product until all repairs are made.
Hard
• No pre-drill holes or markings are provided on our table or desk tops.
• Please check you have all hardware before assembling.
required hardware part and quantity.
• Please retain your receipt as proof of purchase to validate your warranty.
• Keep all hardware parts out of reach of children.
• Heavy product. Do not attempt to lift or move without help
• Do not tighten screws and bolts until completely assembled.
• Failure to follow these warnings could result in serious injury.
NOTE
CAUTION
WARNING

Advertisement

loading

Summary of Contents for Rapidline PO500

  • Page 1 • No pre-drill holes or markings are provided on our table or desk tops. • Please check you have all hardware before assembling. • If you are missing any hardware, please contact your Rapidline reseller. Please ensure you have the name of the item, required hardware part and quantity.
  • Page 2 1. Open Gas lift packaging and Insert gas lift into the 5 star base with castors 2. Place the bellows over the gas lift and press down 3. Fit the seat on top of the gas lift...
  • Page 3 4. Slide the bar of the back into the insert of the mechanism at the back of the seat. *But first pull out the plastic lug then slide the bar in 6. Tighten the knob once reached the desired height. 5.
  • Page 4 PO500 CHAIR W O R K S TAT I O N S F U R N I T U R E S E AT I N G S T O R AG E AC C E S S O R I E S...