PRESONUS NSB Series Owner's Manual page 9

Power User Tip: Because your NSB stage box inputs are most likely routed to multiple sources on your net-
work, PreSonus highly recommends designating one mixer to control the NSB preamps.
Note:You must assign an output stream from your mixer to your NSB-series stage box so that it is
clocked properly over the network. If you do not assign an output stream from your mixer, your networked
stage box will not be properly synced and you will hear audio artifacts. For more information on clocking
over AVB, please review the AVB Networking Guide.
2.1 Direct connect with a StudioLive Series III mixer
In applications where you are using multiple
NSB-series stage boxes of the same model, you
can press the Identify button. This will flash the
Power Network LED on the front of the selected
NSB stage box from green to red, allowing you to
quickly locate your selection.
Select the mixer you'd like to use to control the
preamps on your NSB stage box. By default, this
is set to "All", enabling any StudioLive Series III
mixer on the AVB network to control the preamps
on your stage box.
Select the AVB Output Sends you'd like returned
to the physical outputs on your NSB stage box.
Because the AVB streams must be routed in
banks of 8, you can only source these outputs
from one mixer on the network.
9