PRESONUS NSB Series Owner's Manual page 14

can press the Identify button. This will flash the Power Network LED on the front of the selected NSB stage box
from green to red, allowing you to quickly locate your selection.
5. Select the mixer you'd like to use to control the preamps on your NSB stage box. By
Power User Tip: Because your NSB stage box inputs are most likely routed to multiple sources on your net-
work, PreSonus highly recommends designating one mixer to control the NSB preamps.
6. Select the AVB Output Sends from the StudioLive 24R you'd like returned to the physical outputs on
your NSB stage box. Because the AVB streams are routed must be routed in banks of 8, you can only
source these outputs from one mixer on the network.
Note: You must assign an output stream from your mixer to your NSB-series stage box so that it is
clocked properly over the network. If you do not assign an output stream from your mixer, your networked
2.2 Direct connect with a StudioLive Series III rack mixer
default, this is set to "All", enabling any StudioLive Series III mixer on the AVB net-
work to control the preamps on your stage box.
14