Troubleshooting - Fluval SIENA 332 Instruction Manual

Led strip lights and aquarium

Table of Contents

Available languages

Aquarium Model

LED STRIP LIGHT UNIT

LED STRIP LIGHT MODEL NUMBER

LUMINAIRE WATTAGE

LUMENS

LUMINAIRE OPERATING VOLTAGE

LED DRIVER TYPE (x 2)

LED DRIVER INPUT VOLTAGE

X= B For UK Plug

TROUBLESHOOTING

If an LED Strip Light does not turn on, please proceed as follows:

PROBLEM

The light isn't working.

If the problem is not solved after following the above, please contact your Hagen retailer.

LED STRIP LIGHTS AND TANK MAINTENANCE

CLEANING THE LED STRIP LIGHTS

Disconnect the plug of all the electrical equipment from power supply before any maintenance operation.

WARNING: Be sure you unplug the LED drivers from the power outlet; just switching o the lights with the APP is NOT enough because it does not stop the power supply.

Never place the LED Strip Lights under water jets or submerge in water.

For maximum LED performance, it is recommended that the xtures and LED lens be cleaned on a weekly basis. Unplug the LED drivers prior to cleaning the light xtures. Use

both hands when manipulating these appliances. Wipe exposed surfaces carefully with a damp cloth to remove any dust or mineral deposits that may collect over time. Do not

use detergents or harsh cleaners as it can damage the light xtures.

Use Fluval LED Lens Cleaning Kit (A3969) to clean the LED portion of the light xtures. Make sure all surfaces are dry before re-connecting the LED drivers to the power source.

No special maintenance is required for the Fluval LED Strip Lights and covers, other than periodic cleaning with a damp cloth (never use harsh chemical products or detergents).

To remove calcareous deposits, it is recommended to use a mild acid such as lemon juice, followed by a thorough wipe down with a damp cloth to remove any residue.

SALTWATER AQUARIUMS

It is commonly known that saltwater is far more corrosive, conductive (of electricity) and generally degrades both plastic and metal parts at an accelerated rate versus fresh

water. To minimize salt accumulations on the Fluval Covers and on the LED Strip Lights, it is recommended to take note of the following helpful tips:

1. Make sure lter outputs do not spray above the water surface; position them below the water surface with a slight downward angle,

but still allow for surface movement (contributes to oxygenation).

2. If an air pump must be used, frequent removal of salt deposits will be necessary.

3. Keep the water level as constant as possible (regular top-ups due to evaporation). This is bene cial in providing stable salinity and will help protect the cover.

4. It is recommended to regularly clean all LED Strip Light components that come into contact with saltwater on a weekly basis. The cleaning should be carried out with

a wet cloth (never use harsh chemical products or detergents). Simple lemon juice may be used to take away salt accumulation. Afterwards, rinse carefully to eliminate

every residue of acid.

FLUVAL SIENA LED STRIP LIGHTS SPECIFICATIONS

SIENA 166

BT LED UNIT SIENA

A13253

2 x 22W

2 x 2000 lm

24Vdc

S024AM[X]2400100

100-240Vac

X= V For EU Plug

CAUSE