Table of Contents
Advertisement
4. Operations Guide
Operations Guide
This unit uses DC power. When inputting DC 15V, current cannot be less than 5A, or the system
will not work properly. Before using this device, please charge fully for approximately 10-12
hours.
1. (A) When using DC power, insert one end of DC cord into DC power input jack (4), and insert
the other end into AC power outlet. Switch Power on (1) and the LED indicator (2) lights in
green to indicate normal condition.
(B) When using built-in rechargeable battery, the power LED indicator light (2) is green and
indicates a normal battery. When the power LED indicator light (3) is red, it indicates the
battery power is low and you should recharge or replace it.
(C) If battery power is failing, the main unit will power off automatically.
(D) If you insert the power cord into DC input jack (4), the unit charges automatically.
2. Turn on handheld microphone or body pack transmitter power switch and the RF LED
indicator (2)/(4) on the top panel and the receiver will light. This indicates the signal has
been received properly.
3. If wired microphone is used, insert plug into into a 3.5mm input MIC 1 (8) or an XLR input
MIC 2 jack (10) and adjust the volume control (7 for MIC 1 and 9 for MIC 2), as desired.
4. To connect an external sound source, insert signal cable into LINE IN (14: 3.5mm or RCA
stereo). Volume can be adjusted by LINE IN volume control (13).
5. To use an additional external amplifier, insert one end of signal cable into LINE OUT jack
(15), and the other end to the external amplifier.
6. This unit has TONE (11), REVERB (12), BASS (18) and TREBLE controls (19).
7. Press playback on the MP3/ BT Player to play audio content. Volume can be controlled by
the volume knob (16) on the control board.
8. When connecting with video, insert one end of video out connection to VIDEO OUT jack (17).
9. To make voice a priority over music, turn on the Voice Priority Switch (6). When using the
microphone, music will be lowered automatically to hear the voice. When you stop using the
microphone, the volume of the music will be restored.
10. Voice levels can be controlled by using the Master volume key (20). The Master volume dial
can control the preset volume levels of individual outputs (i.e.: wireless volume level, wired
volume level, MP3/Bluetooth volume level).
Note: Please recharge the built-in rechargeable battery fully before operation.
Switch off the power and plug in the DC cord to start charging. Charging time is
approximately 10-12 hours. Recharge the unit as needed.
If the unit is not to be used for a long period of time, periodically charge the battery.
Turn off the unit, pull out the power plug and turn the Battery Disconnect Switch
to the OFF position.
9
Advertisement
Table of Contents
