Wireless Microphone Parts And Specifications - Hamilton/Buhl VENU100AM Instruction Manual

5. Wireless Microphone Parts and Specifications

Handheld Wireless Microphone (UHF 3V)
1. Open battery cover (6) and insert batteries (pay careful attention to positive and
negative pole positions). Close the battery cover.
2. Turn on microphone power switch (4) and the power LED indicator (2) will flash once then go
off. When indicator (2) stays red, it indicates battery power is low. Please change the
batteries.
3. When turning on the microphone, make sure to select the Stand-By mode for a second
before you switch to the On position to avoid any signal noise.
Wireless Handheld Microphone Specifications
Microphone Type
Frequency
Spurious Emissions
Power Source
Operating Time
On-board Indicators
Dimensions
Weight
10
(1) Mesh cover
(2) Power LED Indicator
(3) Display
(4) Power Switch (Off/Stand-By/On)
(5) Plastic Body
(6) Battery Cover
(7) Cap
Wireless Dynamic Handheld
902MHz~928MHz
>55dBm
2 x "AA" 1.5V Batteries (included)
Approx. >6 Hours
Off/Stand-By/On
Ø 50mm, L 260mm
0.35 lbs
(Orange Tip/Ch 1/915.00MHz)
(Blue Tip/Ch 2/918.70MHz)