Table of Contents
Advertisement
5. Place the rQPOD on the board using the mounting plate, it should slide in from one side then rotate down.
Tighten the TORX screws to hold in place but do not overtighten.
6. Turn the remote control transmitter and make sure that switch F is in the lower position and the throttle stick is
in the center neutral position.
A
NOTE: Make sure switch F is in the lower position for low speed otherwise a warning will be displayed.
CAUTION: If it is raining or damp use the provided transmitter glove – the transmitter is not waterproof
and may fail if it gets wet.
9
Advertisement
Table of Contents
