Weber Rescue Systems IP-BAG SMALL Quick Start Manual

IP-BAG SMALL / IP-BAG LARGE
Part-No. 1101496 / 1101497
Maintenance after underwater use
- If the unit becomes dirty, rinse it thoroughly with clean water to remove mud, silt, algae,
salt water or other contamination.
- After operating underwater or in moisture, the unit must be dried.
- When removing the IP-BAG, check to see if water has entered the drive. If water has entered
the drive - contact your service partner.
- Burnished parts (bolts, blades and lugs) must be greased or preserved.
- The unit remains basically ready for operation after underwater use.
During the next service, inform your service partner that the device was used underwater.
www.weber-rescue.com
* IP-BAG SMALL, ID 1101496
Step 1: Insert the battery on the device and remove any stickers
and dirt in the sealing area for the cuff on the device.
Step 2: Stretch the sealing lip of the IP-BAG sufficiently and pull
the BAG completely over the E-FORCE drive.
Step 3: Pull back the sealing lip slightly to achieve a proper seal.
Note: Pay attention to any overlaps as well as the correct
position of the sealing lip on the cylinder body.
* IP-BAG LARGE, ID 1101497