13
Slide Tray 2 into the printer.
14
Store the lower feeder unit(s) and their tray(s) in a safe place.
Repacking the Printer
Attention
KONICA MINOLTA cannot be held responsible for damage to your
printer during shipment that results from the improper packaging of
your printer.
You must use the instructions given in this section before repacking the
printer in its original shipping carton with the original packing materials
and new waste toner box. If you do not have your original packaging or
new waste toner box, in the Americas, call the Spares department at
(251) 633-4300 extension 2530 and request a magicolor 7300 Series
Return Packaging Kit (part number 2600753-100). For locations outside
the Americas, refer to www.konicaminolta.net/printer/.
If you have been instructed to return the printer to KONICA MINOLTA by
a customer support representative in the Americas, be sure to write the
RMA (Return Merchandise Authorization) number you received on the
outside of the printer carton before shipping the printer. If the RMA
number is not prominently visible on the outside of the return inventory,
we will not accept receipt.
You can also have a KONICA MINOLTA authorized service provider
uninstall and repack your printer, or you can upgrade to on-site service.
For prices and availability, call 1 (877) 778-2687 in the Americas or see
www.konicaminolta.net/printer/ worldwide.
What's involved in repacking the printer?
1
Make sure you have turned off the printer and unplugged the power
supply cord and interface cable(s)
2
Remove all media.
3
Remove the duplex unit kit, and optional lower feeder unit(s) (if they are
attached). (See "Changing the Waste Toner Box" on page 3.)
12
If you are returning the printer for service, you don't need to return
the accessories, documentation, power cord, and interface
cable(s) unless instructed to do so.
Repacking the Printer