Installation Diagram - Mitsubishi Electric Mr.Slim SUY-SM13VA-TH Installation Manual

3. Installation diagram

■
SUY-SM13VA-TH
SUY-SM18VA-TH
A
D
400
150
2-10 mm × 21 mm slot
■
SUY-SM24VA-TH
SUY-SM30VA-TH
417.5
Air inlet
Air inlet
175
Fig. 3-1
6
C
A
B
Drainage hole ({42)
(In case of Heater models {33)
800 69
500
Air inlet
Air outlet
40
81
840
Drainage hole
({42)
40
Air outlet
500
2-10 mm × 21 mm slot
3.1. Outdoor unit (Fig. 3-1)
Ventilation and service space
■
SUY-SM13VA-TH
SUY-SM18VA-TH
A 100 mm or more
B 350 mm or more
C Basically open 100 mm or more without any obstruction in front and on both
sides of the unit.
D 200 mm or more (Open two sides of left, right, or rear side.)
■
SUY-SM24VA-TH
SUY-SM30VA-TH
A 100 mm or more
B 350 mm or more
C 500 mm or more
When the piping is to be attached to a wall containing metals (tin plated) or metal
netting, use a chemically treated wooden piece 20 mm or thicker between the wall
(mm)
and the piping or wrap 7 to 8 turns of insulation vinyl tape around the piping.
Units should be installed by licensed contractor accordingly to local code re-
quirement.
Note:
When operating the air conditioner in low outside temperature, be sure to fol-
low the instructions described below.
• Never install the outdoor unit in a place where its air inlet/outlet side may be ex-
posed directly to wind.
• To prevent exposure to wind, install the outdoor unit with its air inlet side facing
the wall.
• To prevent exposure to wind, it is recommended to install a baffle board on the air
outlet side of the outdoor unit.
(mm)