Fitting Instructions; Operation - S&P ARTIC-255N GR Manual

FITTING INSTRUCTIONS

1. Pass the power cable through the fan base (Fig. 1)
2. Slot the foot of the motor support into the circular fan base and fi x with the rear clips. (Fig. 1)
3. Place the power cable in the groove located in the back part of the base, to ensure that the fan is
stable. (Fig. 1)
4. Loosen the fi xing nut of the rear grille, which is screwed on the motor head.
5. Place the rear protection grille and screw it with the fi xing clamp of the rear grille. (Fig. 2)
6. ARTIC 255N model: Introduce completely the propeller on the motor shaft (Fig. 2)
ARTIC 305N / 405N models: Introduce the propeller fully on the motor shaft and fi x with the fi xing
nut. (Attention to the direction arrow indicated on the fi xing nut) (Fig. 2)
7. Check the propeller by turning it manually. Be sure that the propeller turns freely. If necessary
repeat steps 1 to 3.
8. Place the front protection grille by introducing the hook on the upper part into the rear grille. Put
the two grilles together and press them until they get well placed on the plastic frame.
9. Close the security clamp on the bottom of the front grille and fi x it with the screw.

OPERATION

Once checked that the tension matches with the tension showed on the characteristics plate, plug
the fan and turn the main switch to all the positions.
The ARTIC-255 N model has a three positions switch:
0 = Stop
1 = Low speed
2 = High speed
The ARTIC-305 N and ARTIC-405 N models have a four positions switch:
0 = Stop
1 = Low speed
2 = Medium speed
3 = High speed
OSCILLATION
The fan has a feature which allows the oscillation of the head from side to side of the basis. To make
the fan oscillate, you must press the oscillating switch. To stop the oscillation, just pull the switch
upward (Fig. 3).
SWINGING OF THE HEAD
The ARTIC N fans have a multi-swinging head. To lean it you only have to press over the fan adjus-
ting it to the desired angle (Fig. 3).
9