Table of Contents
Advertisement
a) DOS requires a minimum of 6-channel RC receiver.
b) 4 Receiver channels are used for aileron (channel 1), elevator (channel 2) ，throttle (channel 3) and rudder
(channel 4) signal output. Connect these 4 receiver output signals to the DOS with the supplied wires (pay
attention to the color of each channel ).
c) 2 free Receiver channels are required to control the DOS Flight Modes (a 3-position switch or dial
knob, ‖SW1‖) and Autopilot Mode (a 3-position switch or dial knob, ‖SW2‖).
Wire color
White
(bundled with red &
black)
Orange
Green
Yellow
Brown
Blue
8. GPS interface and Features
a.
Install the GPS Module with the antenna face up (see following picture). DO NOT install next to metal or
carbon fiber and other shielding material, which may block satellite signal.
Install the GPS Module away from electromagnetic sources such as ESC's, power wires, servo wires
b.
and video transmitters.
Color
Function
Guilin Feiyu Electronic Technology Co., Ltd
Guilin Feiyu Electronic Technology Co., Ltd.
Receive channel
Aileron
Elevator
Throttle
Rudder
SW 1
Any free channel controlled by
A 3-way switch or dial knob
SW 2
Any free channel controlled by
A 3-way switch or dial knob
Black
Red
GND
3V
Channel 1
Channel 2
Channel 3
Channel 4
Channel 5
Channel 6
White
GPS Date
http://www.feiyu-tech.com
Page 7
service@feiyu-tech.com
Advertisement
Table of Contents
