Table of Contents
Advertisement
"Gain"window
It's for servo control movement Gain, Set Range:0-100,if
gain number is getting higher, DOS will be getting more
sensitivity.
"Config" Configuration window
Click ―Init GRYO‖ to gyro reset. And our software status bar will prompt initial
success. Don't use it during flying!
Record Attitude:
This function is mainly used to eliminate the installation attitude angle and aircraft
level flight attitude angle deviation. DOS default benchmark angle is o degrees. It's not necessary to adjust. If
you want to adjust more accurate, as follows:
Install DOS on airplane, after setting direction, placed the airplane into level flight attitude, use this
function to record the current attitude which is the basic attitude in ABM.
If DOS is connected with Data Radio, it can be used in flying. Keep airplane level flight, click it to finish the
record attitude.
"Link Mode"setting window
―RC‖ (default) choose RC receiver control.
―RADIO‖choose Data Radio and Remote Adaptor control(for details, please see Remote Adaptor and Data
Radio instructions).
"Install Setting"setting window :
● DOS support four install direction. Front which has LOGO must be installed facing up.
● DOS has an arrow printed on the top of it. Normally Orientate the arrow towards the front of the craft.
● If you adjust the installation direction, it has to be set in software, otherwise you couldn't use DOS to realize
automatic pilot.
Guilin Feiyu Electronic Technology Co., Ltd
Guilin Feiyu Electronic Technology Co., Ltd.
http://www.feiyu-tech.com
Page 16
service@feiyu-tech.com
Advertisement
Table of Contents
