Table of Contents
Advertisement
Elevator
moves up
● If the servo movement is incorrect, you can choose one of these ways to change the control movement as
follows:
1)Adjust it by using DOS setup software through a USB cable.
2)Roll elevator stick on either side of the maximum position of the remote control. On SW1 switch ABM to 3D
mode 6 times, time interval has to be less than 3 seconds as follows:
ABM→3DMode→ABM→3DMode→ABM→3DMode→ABM→3DMode→ABM→3D Mode→ABM→3D Mode,
there is a yellow lamp will light up once, it's done.
D. RUDDER CONTROL SURFACE MOVEMENT CHECK
● Turn your plane clockwise or counter clockwise to see the rudder movement below:
Rudder moves to the left
● If the servo movement is incorrect, you can choose one of these ways to change the control movement as
follows:
1) Adjust it by using DOS setup software through a USB cable.
2) Roll rudder stick on either side of the maximum position of the remote control. On SW1 switch ABM to
3D mode 6 times, time interval has to be less than 3 seconds as follows:
ABM→3DMode→ABM→3DMode→ABM→3DMode→ABM→3DMode→ABM→3D
Mode, there is a yellow lamp will light up once, it's done.
Guilin Feiyu Electronic Technology Co., Ltd
Guilin Feiyu Electronic Technology Co., Ltd.
Elevator Movement In Auto Stabilization Mode
Nose Down
Down
Turn right
Mode
Elevator moves down
Turn left
Rudder moves to the right
http://www.feiyu-tech.com
Page 13
Nose Up
Mode→ABM→3D
service@feiyu-tech.com
Advertisement
Table of Contents
