01 Cleaning The Unit / Pre Filter Replacement; Combined Filter Replacement - Bofa AD1500 iQ User Manual

Table of Contents

Advertisement

Maintenance
6
02
Pre Filter Replacement
The Pre filter needs replacing when the display flashes
between the 2 images shown below, at this point the
buttons will glow Red and if fitted the filter blocked signal
will be given.
To remove and replace the Pre filter follow the procedure
detailed below.
1.
Isolate the electrical supply to the extractor
2. Undo the catches on the front of the unit and open
the door.
3.
The Pre filter is the lower of the 2 filters (refer to
section
1
for filter location) using the handle on the
front of the filter, pull it out of the unit.
4. Once removed it is recommend that the used filters
are bagged and sealed.
5.
Slide the new filter into position making sure it is
pushed all the way in and is located correctly on the
spigot in the back of the unit.
6. Close the door and fasten the 2 latches.

Combined Filter Replacement

The Combined filter needs replacing when the display
flashes between the 2 images shown below, at this point the
buttons will glow Red and if fitted the filter blocked signal
will be given.
To remove and replace the Combined filter follow the
procedure detailed below.
1.
Isolate the electrical supply to the extractor
2. Undo the catches on the front of the unit and open
the door.
3.
The Combined filter is the higher of the 2 filters
(refer to section
1
below the filter through 180
combined filter.
4. Using the handle on the front of the filter, pull it out
of the unit being careful to support it as it comes
free as it is heavy.
5.
Once removed it is recommend that the used filters
are bagged and sealed.
6. Slide the new filter into position making sure it is
pushed in all the way.
7.
Rotate the lever back through 180
filter into position.
8. Close the door and fasten the 2 latches
9. Reconnect the power supply
Both filters MUST be fitted when the extractor is in use, if
the combined filter is not installed correctly the iQ
system will not allow the motor to start.
for filter location) rotate the lever
o
to lower the
0
to raise the

Advertisement

Table of Contents
loading

Table of Contents