Machine Will Not Take In Water After Star - Asko W6021WH Installation And User Manual

MACHINE WILL NOT TAKE IN WATER AFTER STAR-

TING
- Check that the water tap is open.
Proceed as follows:
1. Open the water tap.
2. If the program started more than five minu-
tes ago, restart the program with the
ton.
- Check that the strainer in the machine's water
inlet is not clogged.
Proceed as follows:
1. Close the water tap.
2. Unscrew the hose to the machine's water
inlet.
3. Clean the strainer in the machine's inlet val-
ve.
4. Screw the hose back in place.
5. Open the water tap.
6. If the program started more than five minu-
tes ago, restart the program with the
ton.
If this does not help, call the service depart-
ment.
MACHINE WILL NOT SPIN
- Check for any unbalance in the load.
The machine has an integral unbalance sensor,
which causes the speed to be reduced or spin-
ning to be bypassed if high unbalance is present
in the load. The machine performs all the rinse
sequences, however.
Proceed as follows:
1. Open the door and redistribute the load.
2. Run the Spin program at a suitable speed.
WATER REMAINS IN THE MACHINE AT THE END
OF THE PROGRAM
- Is the button (No spin/No Drain) pressed
in?
The machine has completed the program wit-
hout spinning and does not pump out the water
but- at the end of the program.
Switch off
Spin programs at a suitable speed to remove the
water.
- Is the power supply switched off?
If so, the machine will have stopped in the pro-
gram. Check the fuses in the house. The pro-
gram will continue when the power supply re-
turns.
- Check the drain hose and the drain pump
Proceed as follows:
1. If necessary, straighten out any folds in the
but- drain hose.
2. Has any object become trapped in the outlet
from the drain hose? Clean the hose.
3. Is the drain pump blocked by a foreign body?
Clean the pump; see Chapter 10, Care and cle-
aning.
4. Run either of the Drain or Spin programs at
a suitable speed to remove the water.
PROGRAMS TAKE TOO LONG
If a normal program takes over three hours, for
example, the heating has probably failed to func-
tion. Start a new program. If the fault is repea-
ted frequently, call the service department.
and run either of the Drain or