Preparing The Condensation Container For The Appliance Care Programme; Starting The Appliance Care Programme; Running The Basic Appli- Ance Care Programme On The Appliance - Siemens WQ45G2ABDN User Manual

Table of Contents

Advertisement

en Appliance care
16.2 Preparing the condensa-
tion container for the ap-
pliance care programme
Note: If the condensation is drained
using the drain hose, the condensa-
tion container must be prepared be-
fore the basic or intensive appliance
care programme.
→ "Water drain hose", Page 13
Remove the stopper from the re-
1.
cess in the condensation con-
tainer.
Insert the plug from below.
2.
a The condensation container is
ready for the appliance care pro-
gramme.
Note: If the condensation is drained
using the drain hose, perform the
above-mentioned steps after the ba-
sic or intensive appliance care pro-
gramme in the reverse order.
38
16.3 Starting the appliance
care programme
Requirements
¡ The appliance is ready to run the
appliance care programme.
→ "Preparing the appliance for the
appliance care programme ",
Page 37.
¡ The condensation container is
ready for the appliance care pro-
gramme.
→ "Preparing the condensation
container for the appliance care
programme", Page 38.
Set the programme to position 1.
1.
Press and hold
2.
Set the programme to position 4.
3.
Release
⁠ Iron Dry.
4.
a "CP1" and the programme duration
alternate on the display.
16.4 Running the basic appli-
ance care programme on
the appliance
To remove any light soiling, you can
run a basic appliance care pro-
gramme.
Note: After a certain period of use,
the appliance automatically recom-
mends that you run the basic appli-
ance care programme. Before the
start and end of the programme, the
display shows the note "CrE" for 5
⁠ Iron Dry.

Advertisement

Table of Contents
loading

Table of Contents