Install Carburetor Adapter And Heat Deflector - Kohler CH11-16 Service Manual

Section 11
Reassembly
4. Rocker Bridge Heads - Figure 11-36
Compress the valve spring and seat the push rods
into sockets under the end of the rocker arms.
Rocker Arms
Push Rods
Figure 11-36. Installing Push Rods Under Rocker
Arms (Rocker Bridge Style Heads).
Head with Separate Pivots/Rocker Arms - Figure
11-37
Seat the push rods into sockets under the end of
the rocker arm and align the rocker arms over
the valve stems. Hold the rocker arms in this
position and torque the screws to 11.3 N·m (100
in. lb.). See Figure 11-37.
Figure 11-37. Torquing Rocker Screws.
5. If the head has a threaded hole in the intake port,
install the pipe plug or vacuum line (according to
application). The pipe plug should be installed
for all applications which do not have a metal
vacuum line at this position. Use pipe sealant
with Teflon ® on the threads.
11.12
Compress Valve
Spring
6. Install the spark plug into the cylinder head.
Torque the spark plug to 38.0-43.4 N·m
(28-32 ft. lb.).
Install Carburetor Adapter and Heat
Deflector
1. Install the heat deflector, carburetor adapter, and
gaskets to the cylinder head intake port with the
two allen head capscrews. Torque the screws to
9.9 N·m (88 in. lb.). See Figure 11-38.
Heat
Deflector
Carburetor Adapter
Figure 11-38. Installing Carburetor Adapter & Heat.
Install Baffles and Blower Housing
1. Connect the Oil Sentry™ Indictor Light leads (if
used). See Figure 11-39.
Blower Housing
Figure 11-39. Connecting Oil Sentry™ Indicator
Light Leads.
2. Install the grommet around the high tension lead.
Insert the grommet into the slot in the blower
housing. Install the blower housing and baffles
using hex flange screws. See Figure 11-40 and
11-41.
Indicator Light
Leads