Nokia N86-1 User Manual page 139

Slide handling settings
Select Menu Tools
> >
Slide handling.
Select from the following:
Opening the slide — Set the device to answer an
●
incoming call when you open the slide.
Closing the slide — Set the device to end an active
●
call when you close the slide.
Keyguard activation
●
keypad when you close the slide.
Sensor settings and display
rotation
When you activate the sensors in your device, you can
control certain functions by turning the device.
Select Menu Tools > Settingsand
>
Sensor settings.
Select from the following:
Sensors — Activate the sensors.
●
Turning control — Select
●
Snoozing alarms to mute calls and snooze alarms
by turning your device so that the display faces
down.
Settings and General
>
— Set the device to lock the
General
>
Silencing calls and
Security settings
Phone and SIM
Select Menu Tools
> >
Security Phone and SIM card
>
following:
PIN code request — When active, the code is
●
requested each time the device is switched on.
Deactivating the PIN code request may not be
allowed by some SIM cards.
PIN code, PIN2 code, and
●
change the PIN code, PIN2 code, and lock code.
These codes can only include the numbers from 0 to
9.
If you forget the PIN or the PIN2 code, contact your
service provider. If you forget the lock code, contact
a Nokia Care point or your service provider.
Avoid using access codes similar to the emergency
numbers to prevent accidental dialling of the
emergency number.
Keypad autolock period
●
keypad is locked when your device has been idle for
a certain period of time.
Phone autolock period
●
use, you can set a time-out after which the device
automatically locks. A locked device cannot be used
until the correct lock code is entered. To turn off the
autolock period, select None.
Settings and General
>
and from the
Lock code — You can
— Select whether the
— To avoid unauthorised
139