Operation - Smith MV1000 Parts And Operation Manual

Operation

1. Ensure all LazerVac motor switches are turned to
"OFF". Plug vacuum into grounded power source.
2. Turn Auto Filter Cleaner Power Switch to "ON".
Ensure the sound of the Filter Cleaner Bar is heard
contacting the inside of the filter. If no sound is
heard, replace the Plastic Inserts on the cleaning
bar. See page 18.
3. After 10 seconds, turn on a Vacuum Motor Switch.
Turn on additional vacuum motors if more vacuum
power is needed.
4. LazerVac is now ready for dust collection from the
GrindLazer or other removal equipment.
5. Use the vacuum accessories shown in the section
titled Main Assembly Diagram (LazerVac)
12 to pick up dust from the ground between grinding
passes.
Cyclone LP
1. When Vacuum Collection Bag has collected
approximately 45 lbs (20 kg) of dust, the bag should
be replaced.
2. Pull down on the continuous bag to expose 6 - 12"
(15 - 30 cm) of new, unused bag.
3. Use a cable tie to tie off the top of the bag. Fasten
another cable tie 2" (5 cm) cable tie above the first
cable tie.
4. Put on respirator. Cut the bag between the two
cable ties.
5. Dispose of the dust bag. Follow local ordinances
and regulations for disposal.
6. Pull down on the new bag attached to the vacuum
until the bottom of the bag rests on the bottom of the
vacuum cart. Ensure the bottom of the bag is tied off
firmly with the cable tie.
, page
7