Page 1
Parts/ Operation MV1000 3A5576F Vacuum for collection of dry concrete and asphalt dust. For professional use only. Important Safety Instructions Read all warnings and instructions in this manual before using the equipment. Be familiar with the controls and the proper usage of the...
Troubleshooting ..........................6 Setup ............................6 Operation ............................7 Maintenance ..........................8 Main MV1000 Assembly Diagram ....................9 Main MV1000 Assembly Parts List ..................10 Motor Housing Assembly Diagram ..................11 Motor Housing Assembly Parts List ..................12 Auto Filter Cleaner Assembly ....................13 Notes ............................14 California Proposition 65 ......................15...
Warnings Warnings The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The exclamation point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks. When these symbols appear in the body of this manual or on warning labels, refer back to these Warnings. Product-specific hazard symbols and warnings not covered in this section may appear throughout the body of this manual where applicable.
Page 4
Warnings WARNING GROUNDING This product must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. This product is equipped with a cord having a grounding wire with an appropriate grounding plug. The plug must be plugged into an outlet that is properly installed and grounded in accordance with all local codes and ordinances.
Page 5
Warnings WARNING EQUIPMENT MISUSE HAZARD Misuse can cause death or serious injury. • Do not operate the unit when fatigued or under the influence of drugs or alcohol. • Do not leave the work area while equipment is energized. Turn off all equipment when equipment is not in use.
Connect one end of the Long Vacuum Hose to the Air pressure 3000 mm Aq inlet of the separator. Connect the other end of the Airflow 330 c.f.m long hose to the vacuum hookup on the SMITH Hose 2” (50 mm) Dia. machine. Weight 175lbs (80kg) (net)
Operation 1. Ensure all LazerVac motor switches are turned to Cyclone LP “OFF”. Plug vacuum into grounded power source. 1. When Vacuum Collection Bag has collected approximately 45 lbs (20 kg) of dust, the bag should be replaced. 2. Pull down on the continuous bag to expose 6 - 12” (15 - 30 cm) of new, unused bag.
Maintenance Maintenance Weekly • Inspect Filter Ring Seal for damage. If damaged, replace seal. Ensure seals are installed correctly and properly sealed. DUST AND SHOCK HAZARD To reduce the risk of serious injury: • Respirator must be worn during all maintenance. •...
Parts Main MV1000 Assembly Parts (MV1000) Part Number Description See page 9-11 Motor Housing Assembly See page 13 Auto Filter Cleaner Assembly MV.1.891A Filter (includes item 4) 17X197 Main Body / Filter Seal Rubber Ring MV.1.06 Main Body / Filter Housing...
Parts Motor Housing Assembly Parts List (MV1000) Part Number Description A.HN.25-20 Acorn Nut 17X169 Motor Housing Cover (includes IEC power cord) 1HN.25-20X1.0 Hex Spacer, Long (not shown, located inside item 2) MV.1.07 Set of Motor Rubber Rings and Plastic Net MV.1.06A...
Parts Auto Filter Cleaner Assembly (MV1000) ‡ Part Number Description MV.1.13A Auto Filter Cleaner Assembly Motor Stand MV.3.12B 120V Filter Cleaner Assembly Motor MV.1.12A 230V Filter Cleaner Assembly Motor MV.1.11-C Filter Cleaner Bar, Support (set of 2) MV.1.11-D 4† Filter Cleaner Plastic Insert * MaxiVac 230 and 330 come with one replacement set of item 3 †...
With the exception of any special, extended, or limited warranty published by SMITH, SMITH will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by SMITH to be defective.